Bruker Dimension Icon AFM: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 11: | Line 11: | ||
== Quick start - ScanAsyst mode == | == Quick start - ScanAsyst mode == | ||
* Open the enclosure hood. | * Open the enclosure hood. Red key goes counter-clockwise to unlock. | ||
* From the desktop, open the the ''Nanoscope'' software. This also powers up the tool (red lamp lit on scan head) . | * From the desktop, open the the ''Nanoscope'' software. This also powers up the tool (red lamp lit on scan head) . | ||
* Load the ''ScanAsyst in Air'' experiment. | * Load the ''ScanAsyst in Air'' experiment. | ||
Revision as of 12:08, 24 September 2020
 | |
| Essentials | |
|---|---|
| Full name | Dimension Icon PT |
| Manufacturer | Bruker |
| Description | Atomic Force Microscope |
| Location | K08 |
| Responsibility | |
| Primary | Martin |
| Secondary | Karolis |
Quick start - ScanAsyst mode
- Open the enclosure hood. Red key goes counter-clockwise to unlock.
- From the desktop, open the the Nanoscope software. This also powers up the tool (red lamp lit on scan head) .
- Load the ScanAsyst in Air experiment.
- In the left panel, select Setup.
- In panel 1.1 make sure that the ScanAsyst-Air probe is selected.
- Make sure that the cantilever is visible in the microscope. If you are not sure, zoom all the way out with the controls below the microscope window.
- Perform laser alignment alignment following steps 1.2-1.5.
- In the left panel, select Navigate